In the AOS-CX VSX Inter-Switch Link (ISL) protocol configuration, the dead interval is based on the value set for the hello interval rather than being an independently fixed value. The dead interval is calculated as a multiple of the hello interval, which is consistent with how many keepalive/heartbeat protocols work - if a certain number of hello messages are missed, the peer is declared dead.

Spectrum Monitor is an Aruba AP mode that is sending captured RF data to Aruba Central for waterfall plot.
Spectrum Monitor is a mode that allows an AP to scan all channels in both 2.4 GHz and 5 GHz bands and collect information about the RF environment, such as interference sources, noise floor, channel utilization, etc. The AP then sends this data to Aruba Central, which is a cloud- based network management platform that can display the data in various formats, including waterfall plot. Waterfall plot is a graphical representation of the RF spectrum over time, showing the frequency, amplitude, and duration of RF signals. The other options are incorrect because they are either not AP modes or not sending RF data to Aruba Central.

To establish a keepalive connection between two Aruba CX 8325 switches for VSX configuration, you need to use a routed port in custom VRF. A routed port is a physical port that acts as a layer 3 interface and does not belong to any VLAN. A custom VRF is a virtual routing and forwarding instance that provides logical separation of routing tables. By using a routed port in custom VRF, you can isolate the keepalive traffic from other traffic and prevent routing loops or conflicts. The other options are incorrect because they either do not use a routed port or do not use a custom VRF.
References:
https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6728/bk01-ch07.html
https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6728/bk01-ch02.html

Option B is the correct action that may help fix the issue of sporadic DHCP behavior across clients attached to the CX 6100 switch. Option B enables DHCP relay on VLAN 1000 interface on Core-1 switch, which allows DHCP requests from clients in VLAN 1000 to be forwarded to the DHCP server in a different subnet (10.200.1.100). Without DHCP relay, clients in VLAN 1000 cannot obtain IP addresses from the DHCP server because they are in different broadcast domains. The other options are incorrect because they either do not enable DHCP relay or do not configure it correctly.
References:
https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6728/bk01-ch02.html
https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6728/bk01-ch03.html

The Inter-Switch Link Protocol (ISL) is a protocol that enables the synchronization of data and state information between two VSX peer switches. The ISL uses a version control mechanism and provides backward compatibility regarding VSX synchronization capabilities. The ISL can span long distances (transceiver dependent) and supports different speeds, such as 10G, 25G,
40G, or 100G. One of the data components that the ISL synchronizes is the MAC table, which is a database that stores the MAC addresses of the devices connected to the switch and the corresponding ports or VLANs. The ISL ensures that both VSX peers have the same MAC table entries and can forward traffic to the correct destination. The ISL also synchronizes other data components, such as ARP table, LACP states for VSX LAGs, and MSTP states.