Online Access Free HPE7-A07 Practice Test

A customer wan a gateway connected to a device on gigabitethernet 0/0/3 configures an Asset ID TLV on the device for inventory management.
Exhibit.

The customer mentions me Asset ID is not shown What is causing the issue?

• A.Unknown TLVs cannot be displayed.
• B.LLPD-MED needs to be enabled.
• C.MTU size is too small.
• D.LLDP TX is not enabled.

Based on best practices if an SSID is configured Tor a primary and secondary gateway cluster with cluster preemption enabled, which will decide if the APs move to the secondary gateway cluster if all of the nodes in the primary gateway cluster are down?

• A.cluster leader in the secondary gateway cluster
• B.cluster leader in the primary gateway cluster
• C.every AP individually
• D.tunnel orchestrator for LAN tunnel service in HPE Aruba Networking Central

You recently added ClearPass as an authentication server to an HPE Aruba Networking Central group.
RADIUS authentication with Local User Roles (LUR) works fine Out the same access points cannot use Downloadable User Roles (DUR).
What should he corrected in this configuration to fa the issue with DUR?

• A.Add the correct IP addresses or IP subnets of the Network Access Devices (NADs) under the "Devices" tab on ClearPass
• B.Replace the AP's expiree digital certificate using the "crypto pki-import pem serverCert" command.
• C.Add the correct values for "CPPM username" and "CPPM Password" m the authentication server configuration on HPE Aruba Networking Central
• D.Add a new Enforcement Policy of type ''WEBAUTH'' on ClearPass and associate it with the matching service on ClearPass

A customer has recently deployed AP-615s at their new office and is wondering on which band the radios will operate with the default configuration after creating a tri-band SSID. What should you tell them?

• A.The AP will operate on the 2.4GHz and 6GHz bands
• B.6GHz will not be used unless manually configured
• C.The AP will operate on the 5GHz and 6GHz bands
• D.The AP will operate on the 2.4GHz and 5GHz bands

An OSPF router has learned a path to an external network by both an E1 and an E2 advertisement. Both routes have the same path cost. Which path will the router prefer?

• A.Both routes will be suppressed until the path conflict has been resolved.
• B.The router will use both paths equally utilizing ECMP.
• C.The router will prefer the E1 path.
• D.The router will prefer the E2 path.