Online Access Free JN0-1361 Practice Test

Your WAN links are on a VPLS service from a single service provider. You must verify device configuration power and status in the event of a service outage.
Which two actions provide out-of-band management to your edge routers? (Choose two)

• A.Connect each Ethernet management interface to a dedicated switch with traffic routed on its own subnet on the VPLS service
• B.Place management traffic on a separate VLAN on the VPLS service
• C.Connect each Ethernet management interface to a dedicated switch with its own WAN connection.
• D.Connect each serial management port to a console server with a cellular Internet connection

Exhibit:

You work for service provider B that wants to implement a hot potato routing policy on the network so that router C uses link C-A to reach service provider A's advertised routes and router D uses link D-B to reach Service Provider A's advertised routes Currently traffic from router C is traversing the core to exit the network on router B .
Referring to the exhibit, what are two design actions that would satisfy the requirements? (Choose two.)

• A.Implement BGP-ORR
• B.Configure new IBGP neighbors between routers C and A and routers D and B
• C.Implement BGP-LS
• D.Configure the route reflector to send multiple copies of a route learned from different IBGP peers to its clients.

You are designing several MPLS virtual routing and forwarding (VRF) instances on all provider edge (PE) routers. Routes within each VRF should be exchanged between all PE routers provisioned for that VRF.
For each VRF routing instance which two attributes must match on all related PE routers? (Choose two )

• A.router ID
• B.instance type
• C.interfaces
• D.VRF target

Which two statements about BFD are correct? (Choose two)

• A.NSR maintains BFD sessions during Routing Engine switchover.
• B.GRES is required for BFD sessions to be established.
• C.BFD provides link failure detection for static routes.
• D.BFD modifies each protocol timer to improve link failure detection.

Exhibit:

Referring to the exhibit which type of IPsec VPN should be used to create the desired topology?

• A.fully meshed VPN
• B.hub-and-spoke VPN
• C.AutoVPN
• D.Group VPN