Online Access Free JN0-333 Practice Test

You want to ensure that any certificates used in your IPsec implementation do not expire while in use by your SRX Series devices.
In this scenario, what must be enabled on your devices?

• A.TLS
• B.SCEP
• C.RSA
• D.CRL

You are asked to support source NAT for an application that requires that its original source port not be changed.
Which configuration would satisfy the requirement?

• A.Configure the egress interface to source NAT fixed-port status.
• B.Configure a source NAT rule that references an IP address pool with the port no-translation parameter enabled.
• C.Configure a source NAT rule that sets the egress interface to the overload status.
• D.Configure a source NAT rule that references an IP address pool with interface proxy ARP enabled.

Click the Exhibit button.

You have an IPsec tunnel between two devices. You clear the IKE security associations, but traffic continues to flow across the tunnel.
Referring to the exhibit, which statement is correct in this scenario?

• A.The traffic is no longer encrypted
• B.The IKE security association immediately reestablishes
• C.The traffic is using an alternate path
• D.The IPsec security association is independent from the IKE security association

Click the Exhibit button.

Which statement would explain why the IP-monitoring feature is functioning incorrectly?

• A.The global weight value is too large for the configured global threshold.
• B.The monitored IP address is not on the same subnet as the reth IP address.
• C.The secondary IP address is the same as the reth IP address.
• D.The secondary IP address should be on a different subnet than the reth IP address.

You recently configured an IPsec VPN between two SRX Series devices. You notice that the Phase1 negotiation succeeds and the Phase 2 negotiation fails.
Which two configuration parameters should you verify are correct? (Choose two.)

• A.Verify that the VPN tunnel configuration references the correct IKE gateway.
• B.Verify that the IPsec policy references the correct IKE proposals.
• C.Verify that the IKE initiator is configured for main mode.
• D.Verify that the IKE gateway proposals on the initiator and responder are the same.