Online Access Free JN0-346 Practice Test

Click the Exhibit button. Based on the output shown in the exhibit, which statement is correct?

• A.The ge-0/0/9 interface is using the default priority value.
• B.The ge-0/0/15 interface is using the default port cost.
• C.This switch has been elected as the root bridge.
• D.This switch has a bridge priority of 32k.

Click the Exhibit button. Referring to the exhibit, you are asked to ensure that host-1 can communicate
with host-3 while also allowing host-2 to communicate with host-4. What should you do to enable this
behavior?

• A.Use the all keyword when defining the member VLANs for the ge-0/0/1 interface on both Switch-1 and
  Switch-2.
• B.Configure the native-vlan-id default statement under the ge-0/0/1 port settings on Switch-1.
• C.Use the all keyword when defining the member VLANs for the ge-0/0/1 interface on Switch-1.
• D.Configure the native-vlan-id default statement under the ge-0/0/1 port settings on both Switch-1 and
  Switch-2.

Which static route next-hop value indicates that the packet will be silently dropped?

• A.reject
• B.discard
• C.resolve
• D.next-table

Host-1 was recently added in the network and is attached to ge-0/0/10 on Switch-A. Host-1 is powered on
and has its interface configured with default Layer 2 settings and an IP address on the 172.17.12.0/24 IP
subnet. Host-1's MAC address is not shown in Switch-A's bridging table. What are three explanations for
this state? (Choose three.)

• A.The ge-0/0/10 interface is configured as an access port.
• B.The ge-0/0/10 interface is configured as a trunk port.
• C.The ge-0/0/10 interface has not received any traffic from Host-1.
• D.The ge-0/0/10 interface does not have an associated IRB.
• E.The ge-0/0/10 interface is not operationally or administratively up.

Click to the exhibit button. Referring to the exhibit, which configuration change is needed for an IS-IS
Level 1 adjacency between R1 and R2?

• A.Configure the Io0 family ISO address 49.0002.0010.0042.0002.00 on R2.
• B.Configure the Io0 family ISO address 49.0002.0010.0042.0002.00 on R1.
• C.Enable Level 2 on R1's ge-0/0/1 interface.
• D.Disable Level 2 on R2'sge-0/0/1 interface.