Online Access Free JN0-349 Practice Test

Routet-1 and Router-2 must connect through the Internet using a tunneling technology. Hosts that are connected to Router-1 and Router-2 will be sending traffic up to 1500 bytes. The maximum segment size that is supported across the path is 1520 bytes.
Which tunneling technology will allow this communication to take place?

• A.GRE tunnel
• B.IPsec VPN transport mode
• C.IPsec VPN tunnel mode
• D.IP-IP tunnel

Your BGP router receives routes from two upstream ISPs: ISP A and ISP B.
In this scenario, which change would you make to prefer routes from ISP A?

• A.Set the local-preference attribute for all routes received from ISP A to 50 while all routes received from ISP B use the default local-preference value of 100.
• B.Change the MED value for all routes received from ISP A to 1 while all routes from ISP B remain configured with no MED value.
• C.Set the local-preference attribute for all routes received from ISP A to 200 while all routes received from ISP B use the default local-preference value of 100.
• D.Prepend the AS path to all routes received from ISP A while all routes received from ISP B use the default AS path value.

Which two statements about a unified ISSU are correct? (Choose two.)

• A.It is only supported on platforms with redundant control planes.
• B.It is only supported on platforms with redundant power supplies.
• C.It requires that Bidirectional Forwarding Detection be disabled.
• D.It requires that graceful Routing Engine switchover be enabled.

You are asked to configure filter-based forwarding (FBF) to forward traffic sourced from a specific subnet to a webserver.
In this scenario, which mechanism is used to add interface routes to the forwarding routing instance used in FBF?

• A.forwarding policy
• B.routing policy
• C.RIB groups
• D.generated routes

You are configuring IS-IS on the newly provisioned ae88 interface. After you commit the configuration, you notice that your adjacency is not showing up.

Referring to the exhibit, what is the reason for the adjacency being down?

• A.R1 and R2 are in different IS-IS levels.
• B.R1 and R2 have different interface parameters.
• C.R1 and R2 are configured for different metrics.
• D.R1 and R2 are configured for different areas.