Online Access Free JN0-351 Practice Test

Which statement is correct about the storm control feature?

• A.The storm control feature is enabled in the factory-default configuration on EX Series switches.
• B.The storm control feature is not supported on aggregate Ethernet interfaces.
• C.The storm control feature requires a special license on EX Series switches.
• D.The storm control configuration only applies to traffic being sent between the forwarding and control plane.

Which two events cause a router to advertise a connected network to OSPF neighbors? (Choose two.)

• A.When an interface has the OSPF passive option enabled.
• B.When an OSPF adjacency is established.
• C.When a static route to the 224.0.0.6 address is created.
• D.When a static route to the 224.0.0.5 address is created.

Exhibit.

The ispi _ inet. 0 route table has currently no routes in it.
What will happen when you commit the configuration shown on the exhibit?

• A.The inet. 0 route table will be completely overwritten by the ispi . inet. 0 route table.
• B.The ISPI . inet. 0 route table will be imported into the inet. 0 route table.
• C.The inet. 0 route table will be imported into the ispi . inet. 0 route table.
• D.The ISPI . inet. 0 route table will be completely overwritten by the inet. o route table.

Exhibit.

What is the management IP address of the device shown in the exhibit?

• A.10.210.20.233
• B.128.0.0.1
• C.172.23.11.10
• D.172.23.12.100

You are asked to create a new firewall filter to evaluate Layer 3 traffic that is being sent between VLANs. In this scenario, which two statements are correct? (Choose two.)

• A.You should apply the firewall filter to the appropriate VLAN.
• B.You should create a family inet firewall filter with the appropriate match criteria and actions.
• C.You should apply the firewall filter to the appropriate IRB interface.
• D.You should create a family Ethernet-switching firewall filter with the appropriate match criteria and actions.