Online Access Free JN0-481 Practice Test

What is the primary benefit of using ZTP (Zero Touch Provisioning) in conjunction with Juniper Apstra?

• A.It replaces the need for Device Profiles.
• B.It is only used for spine devices.
• C.It allows newly connected devices to automatically boot, obtain an image and initial configuration, and register with Apstra without manual intervention.
• D.It eliminates the need for an Apstra server.

You are using Juniper Apstra to create logical devices and interface maps. You use them in three different rack types. You then modify the logical devices to support the required increased interface speeds and receive an error message when updating the logical devices.
Referring to the exhibit, which action is needed to remove the error?

• A.Remove any templates, racks, and interface maps that reference the logical device.
• B.Remove any interface maps that reference the logical device.
• C.Remove any racks that reference the logical device.
• D.Remove any templates that reference the logical device.

What are two available Juniper Apstra template types? (Choose two.)

• A.compressed
• B.collapsed
• C.rack-based
• D.device-based

You must enable ECMP load balance in your three-stage EBGP IP Clos fabric.
In this scenario, which two features are required? (Choose two.)

• A.multihopapplied to the BGP group
• B.a load-balance policy applied to the BGP group
• C.a load-balance policy applied to the forwarding table
• D.mutlipath multiple-asapplied to the BGP group

In Juniper Apstra, what is the purpose of the "Build" tab within a blueprint?

• A.It displays the physical cabling diagram only.
• B.It is used exclusively for firmware upgrades.
• C.It manages user authentication settings.
• D.It provides visibility into staged versus active configuration differences and allows committing changes.