Online Access Free JN0-681 Practice Test

You are configuring an IP Fabric in your data center and you are trying to load-balance traffic across multiple equal-cost BGP routes. You have enabled multipath, but the traffic is not being load-balanced.

Referring to the exhibit, what will solve this problem?

• A.You should apply the load-balance policy as an export policy to the forwarding table
• B.You should apply the load-balance policy as an export policy for the BGP neighbor
• C.You should apply the load-balance policy as an export policy to the BGP neighbor
• D.You should apply load-balance policy as an import policy to the forwarding table

You need to add perimeter security to the network shown in the exhibit. All traffic must be inspected for attacks. The edge routers are using all available ports. Your solution must maintain both port and device resiliency.

In this scenario, which design would satisfy these requirements?

• A.one-arm SRX Series device using LAG
• B.one-arm SRX Series chassis cluster
• C.inline SRX Series chassis cluster
• D.inline SRX Series device using LAG

You want to configure redundant Layer 3 gateways
In this scenario, which two juniper best practices would accomplish this task? (Choose two.)

• A.Configuring both IRB interfaces manually with the same IP address
• B.Allowing Junos to dynamically create the virtual MAC address of the IRB interface
• C.Configuring both IRB interfaces manually with the same address
• D.Allowing Junos to dynamically create the virtual IP address of the IRB interface

Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?

• A.VXLAN Layer 3 gateway must be provisioned at the Super Spine layer.
• B.VTEP and VTEP2 must peer using IBGP.
• C.A route to the loopback address on VTEP must be present on VTEP1.
• D.The service provider WAN connection be an MPL5-based WAN connection.

You are implementing perimeter security for your data center. You need to inspect all traffic Layer 7 and ensure the failure of a port or device will not result in an interruption to traffic flows.
In this scenario, which design would satisfy these requirements?

• A.QFX Virtual Chassis
• B.MX with MC LAG
• C.SRX using LAG
• D.SRX Chassis cluster