Online Access Free JN0-682 Practice Test

Your colleague has begun working on the base configuration for an active-active multihomed EVPN connection shown in the exhibit.

Which two actions will ensure a successful implementation? (Choose two.)

• A.Change the ESI mode on PE2 to all-active
• B.Change the ESI value on the PE1 device to 00.22.44.88.00.22.44.66.88
• C.Change the ESI value on the PE2 device to 00.00.00.00.00.00.00.00.00.00
• D.Change the ESI mode on PE1 to signal-active

What are three advantages of using MPLS for data center interconnects? (Choose two.)

• A.Any to any connectivity
• B.Dedicated connections between customer sites
• C.Dedicated MPLS backbones for Layer 1 and Layer 3 DCIs
• D.Traffic engineering
• E.Sub 50 ms failover times

You are asked to deploy an Ethernet bridging design in a data center with the following criteria:
- routing must occur on the leaf devices.
- VTEPs must terminate on the leaf devices.
- facilitate inter-VLAN communication.
- lower latency with East-West traffic.
Which architecture should you use in this scenario?

• A.collapsed spine architecture
• B.bridge overlay architecture
• C.centrally-routed bridging architecture
• D.edge-routed bridging architecture

You are deploying a VXLAN using signaling overlay network in your new data center. You are able to establish your MP BGP peering session and see your EVPN routes, but traffic will not traverse the VXLAN using signaling overlay network.
What is a solution to this problem?

• A.Increase the protocol MTU on all devices participating in VXLAN using EVPN signaling
• B.Increase the MTU on the logical VTEP source interface of all devices participating in VXLAN using EVPN signaling.
• C.Enable the mtu-discovery feature on the MP peering sessions between VXLAN ANs EVPN signaling peers.
• D.Increase the physical MTU on all ports on all devices participating in VXLAN using EVPN signaling.

You are considering deploying a MAC-VRF type routing instance with a VLAN-bundle service type. In this scenario, which two statements are correct? (Choose two.)

• A.It can be implemented in a bridge overlay architecture.
• B.VLAN normalization is supported.
• C.Multiple VLAN IDs per EVI are supported.
• D.It can be implemented in an ERB architecture.