Online Access Free JN0-683 Practice Test

Referring to the exhibit, Host1 (10.1.1.1) if failing to communicate with Host2 (10.1.2.1) in a data center that uses an ERB architecture.
What do you determine from the output?

• A.Host1 and Host2 are directly connected to leaf1.
• B.The irb.20 interface is not configured on leaf1.
• C.The traffic is entering the VXLAN tunnel.
• D.The traffic is failing because load balancing is not configured correctly.

You are preparing an sFlow monitoring system configuration. In this scenario, what Information will be included in the datagram sent to the sFlow collector? (Choose two.)

• A.the source and destination VLAN for sampled packets
• B.the CRC from the sampled packet
• C.the sending device's serial number
• D.the interlace through which the packets entered the agent

Which statement is correct about a collapsed fabric EVPN-VXLAN architecture?

• A.Border gateway functions occur on border leaf devices.
• B.It supports multiple vendors in the fabric as long as all the spine devices are Juniper devices deployed with L2 VTEPs
• C.Fully meshed back-to-back links are needed between the spine devices.
• D.Using Virtual Chassis at the leaf layer increases resiliency.

You are designing a DCI solution and want to prevent the extension of BUM traffic and Ethernet Segment information between data centers while still allowing IP prefix reachability. Which EVPN seamless stitching type should you use?

• A.Type 3 seamless stitching using multicast replication.
• B.Type 2 seamless stitching using border leaf VXLAN tunnels.
• C.Type 1 seamless stitching using Layer 2 stretching.
• D.Type 5 seamless stitching using only IP Prefix routes.

In your EVPN-VXAN environment, you want to prevent a multihomed server from receiving multiple copies of BUM traffic in active/active scenarios. Which EVPN route type would satisfy this requirement?

• A.Type 8
• B.Type 5
• C.Type 4
• D.Type 7