Question 1
A technician is installing a cable modem In a SOHO. Which of the following cable types will the technician MOST likely use to connect a modem to the ISP?
Question 2
A network technician is installing an analog desk phone for a new receptionist After running a new phone line, the technician now needs to cnmp on a new connector. Which of the following connectors would MOST likely be used in this case?
Question 3
A network technician needs to set up an access method for Ann, a manager, to work from home. Ann needs to locally mapped corporate resources to perform her job. Which of the following would provide secure access to the corporate resources?
Question 4
In which of the following ways does a DDoS attack differ from a spoofing attack?
Question 5
SIMULATION
You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch. The network must meet the following parameters:
The SSIDs need to be configured as CorpNet with a key of S3cr3t!
The wireless signals should not interfere with each other.
The subnet the Access Points and switch are on should only support 30 devices maximum.
The Access Points should be configured to only support TKIP clients at a maximum speed.
INSTRUCTIONS
Click on the devices to review their information and adjust the settings of the APs to meet the given requirements.
If any time you would like to bring back the initial state of the simulation, please click the Reset All button.









You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch. The network must meet the following parameters:
The SSIDs need to be configured as CorpNet with a key of S3cr3t!
The wireless signals should not interfere with each other.
The subnet the Access Points and switch are on should only support 30 devices maximum.
The Access Points should be configured to only support TKIP clients at a maximum speed.
INSTRUCTIONS
Click on the devices to review their information and adjust the settings of the APs to meet the given requirements.
If any time you would like to bring back the initial state of the simulation, please click the Reset All button.









