Question 11

A technician is connecting a PC to a switchport. At the wiring closet, the technician is identify which cable goes from patch panel a connected to the switch to patch panel B connected to the PC. Which of the following tools should the technician use to resolve the issue?
  • Question 12

    A network technician is diagnosing a time-out issue generated from an end user's web browser. The web browser issues standard HTTP get and post commands to interact with the website. Given this information, the technician would like to analyze the entire TCP handshake of the HTTP requests offline. Which of the following tools would allow the technician to view the handshake?
  • Question 13

    The IT manager at a small firm is in the process of renegotiating an SLA with the organization's ISP. As part of the agreement, the organization will agree to a dynamic bandwidth plan to provide
    150Mbps of bandwidth. However, if the ISP determines that a host on the organization's internal network produces malicious traffic, the ISP reserves the right to reduce available bandwidth to 1.5 Mbps. Which of the following policies is being agreed to in the SLA?
  • Question 14

    You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch. The network must meet the following parameters:
    The SSIDs need to be configured as CorpNet with a key of S3cr3t!
    The wireless signals should not interfere with each other.
    The subnet the Access Points and switch are on should only support 30 devices maximum.
    The Access Points should be configured to only support TKIP clients at a maximum speed.
    INSTRUCTIONS
    Click on the devices to review their information and adjust the settings of the APs to meet the given requirements.
    If any time you would like to bring back the initial state of the simulation, please click the Reset All button.








    Question 15

    While attempting to add a new computer to the company network the network technician is unable to connect automatically. The technician runs a command and is presented with the following output:

    The technician assigns a static IP address and is able to connect to the network. Which of the following BEST describes the cause of the issue?