The document that would most likely be used to review disaster recovery information for a system is a business continuity plan (BCP). A BCP is a document that outlines the procedures and resources needed to maintain or resume critical business functions in the event of a disaster or disruption. A BCP typically includes a disaster recovery plan (DRP), which is a subset of the BCP that focuses on restoring IT systems and data after a disaster. A BCP also covers other aspects of business continuity, such as risk assessment, business impact analysis, emergency response, crisis management, and testing. References: CompTIA Network+ N10-008 Certification Study Guide, page 346; The Official CompTIA Network+ Student Guide (Exam N10-008), page 13-9.

The 802.11b standard is a wireless networking protocol that operates in the 2.4GHz frequency band and supports a maximum data rate of 11Mbps. It uses a 20MHz channel width and a direct-sequence spread spectrum (DSSS) modulation technique2. The 802.11b standard was released in 1999 and is backward compatible with the original 802.11 standard3. The other standards do not match the specifications given by the customer. 802.11ac operates in the 5GHz band and supports higher data rates up to 6.9Gbps. 802.11g also operates in the 2.4GHz band but supports data rates up to 54Mbps. 802.11n can operate in both 2.4GHz and 5GHz bands and supports data rates up to 600Mbps. It also uses a wider channel width of 40MHz and a multiple-input multiple-output (MIMO) technology3.
Reference
2 - 802.11 Standards Explained: 802.11ax, 802.11ac, 802.11b/g/n, 802.11a - Lifewire
3 - Introduction to WLAN Frequency Bands | Engineering Education (EngEd ...

ESP stands for Encapsulating Security Payload, and it is a protocol that provides confidentiality, integrity, and authentication for IP packets. ESP encrypts the payload of the IP packet, which contains the data stream, and adds a header and a trailer that contain security information. ESP can be used to create a secure communication link between two sites by using a VPN tunnel that protects the data stream from unauthorized access or modification. GRE stands for Generic Routing Encapsulation, and it is a protocol that encapsulates one network protocol inside another. GRE does not provide encryption or security by itself, but it can be combined with ESP or other protocols to create a secure VPN tunnel. IKE stands for Internet Key Exchange, and it is a protocol that negotiates and establishes security associations for IPsec, which is a suite of protocols that includes ESP and AH. IKE does not encrypt or protect the data stream, but it enables the secure exchange of keys and parameters for IPsec. AH stands for Authentication Header, and it is a protocol that provides integrity and authentication for IP packets. AH does not encrypt the payload of the IP packet, which means the data stream is not confidential. AH adds a header that contains security information and a checksum that verifies the integrity of the packet

Explanation
10GBASE-LR is a standard for 10 Gbps Ethernet over single-mode fiber optic cable. It can support a maximum distance of 6.2 miles (10 km), which is much longer than the distance between the buildings.
10GBASE-SW, 10GBASE-LX4, and 10GBASE-SR are all standards for 10 Gbps Ethernet over multimode fiber optic cable, which have shorter maximum distances ranging from 984ft (300m) to 1,312ft (400m).
References: CompTIA Network+ Certification Exam Objectives Version 7.0 (N10-007), Objective 1.5:
Compare and contrast network cabling types, standards and speeds.

The RFC1918 IP space is a set of private IP addresses that are not routable on the public Internet and can be used for internal networks. The RFC1918 IP space consists of three ranges: 10.0.0.0/8, 172.16.0.0/12, and 192.168.0.0/161 Out of the four options, only A . 10.10.10.0/24 belongs to one of these ranges, specifically the 10.0.0.0/8 range. Therefore, the technician should use this subnet for the LAN.
Reference
1: https://en.wikipedia.org/wiki/Private_network