Online Access Free NACE-CIP1-001 Practice Test

Surface profile describes:

• A.The general condition of the surface required after abrasive blasting
• B.The level of surface roughness required after abrasive blasting
• C.The initial condition of the surface prior to abrasive blasting
• D.The level of surface cleanliness required after abrasive blasting

ISO ST 3 is described as:

• A.Thorough hand tool cleaning
• B.Very Thorough power tool cleaning
• C.Thorough blast cleaning
• D.Very Thorough hand or power tool cleaning

As a NACE Coating Inspector your responsibility with respect to safety is to:

• A.Check the PPE used by the Applicators
• B.Assume the role of the Safety Inspector
• C.Act in accordance with the site safety requirements and set an example
• D.Check the credentials of the Safety Officer on site

The main responsibilities of the inspector are to

• A.demonstrate to the contractor how to apply the coating.
• B.observe and report the quality of the work performed.
• C.observe and direct the work of the contractors.
• D.direct and perform the work stated in the specification.

Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator's cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his "insurance policy" for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

• A.Meet with the owner and explain your limitations and concerns prior accepting the assignment
• B.Review the Product Data Sheets and meet with the Coating Applicator 'prior to the pre-job meeting
• C.Purchase Professional Liability Insurance prior to job commencement
• D.Review the Product Data Sheets, and conduct a walk thru of the job site prior to the pre-job Conference