Online Access Free NCP-BC-7.5 Practice Test

An administrator is validating a newly created Recovery Plan and receives the following warning:
IP addresses xxx.xxx.xxx.xxx cannot be preserved/mapped for VM REPORTVM01.
IP addresses cannot be preserved/mapped for entities
IP might be already in use or will be used by some other VM for recovery. IP cannot be mapped.
Only one IP address can be preserved for a vNIC in an IP address management enabled network.
What can the administrator do to resolve this warning without changing the existing IP address assigned to the VM?

• A.Configure Custom VM IP Mapping in the Recovery Plan to define explicit IP address mapping for the VM.
• B.Add an additional vNIC to the VM and assign the IP address to the new vNIC to bypass the IPAM conflict.
• C.Remove and re-add the VM to the Recovery Plan to trigger a fresh IP address mapping validation.
• D.Disable IPAM on the recovery site subnet to allow Nutanix DR to preserve static IP addresses during failover.

An administrator logs into Prism Central (PC) and notices that a replication of a recovery point is still ongoing from Cluster A to Cluster B on a new setup.
* The bytes being replicated aren ' t changing.
* Both site ' s virtual IP addresses are reachable.
* Connectivity between PC/PE is good.
* There is a dedicated LAN between the clusters.
What could be causing this replication to be stuck?

• A.Port 2030 is blocked between CVMs.
• B.Protection Policy is incorrectly configured.
• C.Port 2020 is blocked between CVMs.
• D.Acropolis is down at the Remote Site.

An administrator has recently completed the initial configuration of Nutanix Disaster Recovery for a production environment. Protection Policies and Recovery Plans have been configured and validated by the senior infrastructure team.
The administrator has confirmed that the expected categories are correctly associated with both the Protection Policies and Recovery Plans. During a scheduled test failover, the administrator notices that several VMs are missing from the recovery.
The administrator reviews the environment and notes the following:
* The Protection Summary tab does not show any warnings or errors
* No replication tasks are currently ongoing
* The missing VMs were all deployed within the last two weeks as part of a new application rollout
* The missing VMs are running on the same cluster as other VMs that recovered successfully during the test failover
* The application team followed the standard VM deployment checklist but did not coordinate with the infrastructure team during provisioning Given this information, what is the most likely cause of the missing VMs?

• A.The Protection Policies experienced replication lag during the two-week period.
• B.The Recovery Plans were not re-synchronized after the new VMs were deployed.
• C.The newly deployed VMs were not assigned the correct categories during provisioning.
• D.The new VMs require an initial full replication before they are eligible to appear in a test failover.

How does the system behave if the network cannot sustain the data change rate required to maintain a 1- minute RPO between the primary and recovery AZs?

• A.The VMs continue to be protected in 1-minute RPO, but write I/O is degraded.
• B.The protected VMs are failed over.
• C.All write I/O to the protected VMs is paused.
• D.The system automatically switches to Asynchronous replication mode.

A VM is protected in an Async Protection Policy and added to a Recovery Plan. An administrator is attempting to perform a planned failover of the VM. How many recovery points are created and replicated during the planned failover process?

• A.One recovery point is created while the VM is powered off.
• B.One recovery point is created while the VM is powered on and one while the VM is powered off.
• C.One recovery point is created per VM when the VM is powered on.
• D.No recovery points are created and the last successfully replicated recovery point is used to restore the VM.