Free Access Nutanix.NCS-Core.v2024-09-11.q146 Practice Test (Page 21)

Question 96

An alert about RX errors on eth2 on a node is reported in the cluster. The administrator logs in to the CVM in question, checks the ping_* files in the data/logs/syststats folder, and notices intermittent ping loss.
The node in question has the following network configuration:

Which action should be used to troubleshoot without disrupting the VMs running on this node?

A.Replace the cable from eth2 to the switch

B.Remove eth3 from br0-up and monitor for new alerts

C.Check the port on the switch side for any errors

D.Enable balance-s1b on br0-up and monitor if a problem persists

Question 97

During the Foundation imaging process, nodes are successfully imaged, but the cluster creation fails.
Which log should the consultant review to determine the cause?

A.foundation.out

B.genesis.out

C.first_boot.log

D.service.log

Question 98

An administrator needs to initiate a new VDI project within a couple of months. Prism Central reports there are no storage resources to accommodate such workloads.
The administrator sees many powered-off VMs and has the authority to delete test VMs powered off at least for 30 days. Test VMs belong to the Test category.
Using Prism Central, which steps are required to identify the correct VMs to be deleted?

A.Use Capacity Runway to filter by Test and Powered-off VMs

B.Filter VMs list, choose Test category and Inactive under Efficiency

C.Create a new Scenario selecting Test VMs. filter by uptime

D.Create a new Project selecting Test VMs, sorting by power state

Question 99

An administrator needs to install prism central for their 2550 multi-cluster environment.
How should they deploy the application?

A.Deploy a small 1-VM Prism Central instance.

B.Deploy a large 1-VM Prism Centralinstance.

C.Deploy a large 3-VM Prism Central instance

D.Deploy a small 3-VM Prism Central instance.

Question 100

An administrator is configuring an All Flash cluster to support the following workloads:
* Full clone virtual desktops
* Hadoop
* Write heavy databases
Which three correct configuration options should the administrator use to meet the item requirements?
(Choose three.)
For each procedure, indicate whether it is a correct or incorrect procedure that must be configured to meet the item requirements using the drop-down option.