An administrator is concerned that Prism will be inaccessible if Active Directory is unable to process logins.
Which method should the administrator use to access the cluster in the event of this type of outage?

After uploading a hypervisor ISO during the Foundation process, a consultant sees a message that the MD5 sum for the hypervisor is not found in the Whitelist file.
Which step should the consultant take next to resolve this issue?

A consultant is completing final network failover testing on a recently deployed AHV cluster.
The cluster consists of the following:
*Three nodes
*Two uplinks connected to two switches
*Supported SFPs
The consultant removed one SFP+ out of each node. Two of the nodes (Hostl I Host2) failed over to the backup NIC correctly without any interruption but have lost communication with the third node (Host 3) hypervisor/CVM. Inserting the original SFP+ back into the problematic node allowed the network to be connected and the two healthy nodes could communicate successfully again.
manage_ovs showjnterfaces output
manage_ovs showjinterfaces output:
name mode link speed
cthO 10000 True 10000
ethl 10000 False None
eth2 10000 True 10000
eth3 10000 False None
manage_ovs show.uplinks output:
Bridge: brO
Bond: brO-up
bond_mode: active-backup
interfaces: ethl ethO
lacp: off
lacp-fa I 1 back: false
lacp_speed: slow
What should the consultant validate first?

After deploying an AHV cluster connected to Cisco Nexus 9k switches, unexpected network behavior is observed. The consultant needs to rule out physical network mis-cabling without returning to the datacenter.
Which command from the host should the consultant run?

A consultant is unable to ping the CVM from the hypervisor using the external interface. The customer's network is configured with the 10.3.12.0/24 subnet without VLAN tagging. The CVM and hypervisor are using the same address space.
What is causing this issue?