A consultant is performing a Nutanix Cluster installation on Dell XC Core hardware. The consultant decides to use Foundation Portable for Mac to perform the installation. When the consultant arrives onsite, Foundation Portable is unable to locate the new nodes.
Which log should the consultant check to troubleshoot this issue?

An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the followingconsiderations:
* Individual VMs will likely generate network throughputs in the range of 90-100Mbps
* Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time
* Individual VMs will communicatewith only a few (one or two) remote hosts at a time
* Multicast will not be used in the environment
* The hosts are connected via two 1GbE network connections
How should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?

A consultant is unable to ping the CVM from the hypervisor using the external interface. The customer's network is configured with the 10.3.12.0/24 subnet without VLAN tagging. The CVM and hypervisor are using the same address space.
What is causing this issue?

A customer racks all nodes in the new cluster. The customer does not allow IPv6 for node discovery.
The consultant is not allowed to use the consultant's own flat switch in the customer's environment.
Which step should the consultant take to resolve this issue?

A consultant attempts to perform an LCM inventory after successfully creating the cluster, but is met with the following error:
LCM Exception [LcmExceptionHandler]: Could not find a module for entity with reference name nutanix.ncc.
update
What is the most likely reason LCM inventory/update is failing?