Online Access Free NS0-093 Practice Test

An aggregate has experienced a multiple disk failure due to a failing I/O module (IOM). The module has been replaced and the aggregate is still failed.
What step can be taken to recover the aggregate?

• A.Use diskcopy from maintenance mode.
• B.Unfail the drives from maintenance mode.
• C.Unfail the drives in the order that they failed from the clustershell
• D.Run wafliron from the boot_menu.

What happens when the command diskcopy is run from nodeshell?

• A.It pre-fails a drive in an aggregate and copies it to a spare.
• B.It performs a low-level copy of the disk to another disk.
• C.It triggers a RAID reconstruction of that disk.
• D.It copies the disk content to a specified volume.

Which two steps are required to replace a drawer in a DS460c shelf? (Choose two.)

• A.Evacuate all drives in the drawer.
• B.Shut down both nodes.
• C.Power off the shelf.
• D.Disconnect the cable chains from the chassis.

Which two ONTAP systems support both SSD and SAS disks? (Choose two.)

• A.AFF A220
• B.AFF C190
• C.FAS8200
• D.FAS2750

You are replacing a boot device on a FAS8300 system that is running ONTAP 9.10P6 software. You attach a USB memory stick to the external USB port on the storage controller but cannot access the memory stick.
What step needs to be performed to access the boot device?

• A.The external USB port is not activated on NetApp systems.
• B.Add the boot device before the BIOS is loaded.
• C.You need to use ONTAP 9.11 or later software.
• D.Set the port to "enabled" with setenv.