Online Access Free NS0-181 Practice Test

Referring to the exhibit, which statement describes the duster network used by the cluster interconnect ports?

• A.The network used to allow all nodes to communicate for internal (private) data access.
• B.The network used to allow all nodes to communicate with the users for data access.
• C.The network used to allow all nodes to communicate with the customer (or management access.
• D.The network that allows all nodes in the cluster to have direct access to every other node's disk shelves.

Select the Exhibit tab.

Your customer has an AFF A300 installed. They ask you to configure the e0a and e0b ports to use the FC protocol.
Referring to the exhibit, which statement is correct in this scenario?

• A.These ports are used for the cluster interconnect.
• B.These ports are used for the Ethernet uplink into the customer's network.
• C.Use the ucadmin command to configure these ports as FC ports.
• D.The configuration of these ports can only be done by OnCommand System Manager.

You want to grow your current ONTAP cluster. You have a Cisco Nexus 5596UP that is currently using all of its on-board ports.
Which statement is correct in this situation?

• A.Add expansion modules to the Cisco switches.
• B.Pull the redundant cables from each node to obtain more free ports on the switch.
• C.Contact NetApp Support to order new switches.
• D.Add new SFP modules to the empty on board ports on the Cisco switches.

Your customer has filled out the customer installation worksheet. However, the customer's network environment is not set up and ready for the new ONTAP 9.1 system. The customer requests that you install the system and states that they will finish the configuration when they have acquired the appropriate network connections.
Which two statements are correct about this scenario? (Choose two.)

• A.You should cable a cluster so that the clusters interconnect traffic is on a separate network from all other traffic.
• B.A cluster can be created without data network connections, but it must include a cluster interconnect connection.
• C.You should cable all of the controllers and disk shelves, power on the system, and then leave the system as-is for the customer to configure.
• D.You cannot install an ONTAP system without having the customer network configuration.

What is a valid failover policy for a SAN LIF?

• A.disabled
• B.system-define
• C.broadcast-domain-wide
• D.local-only