Question 1
Which three components are required when setting up a new ONTAP cluster? (Choose three.)
Question 2
Click the Exhibit button.
Your ONTAP cluster shows the cluster network errors that are shown in the event log.
What is used by ONTAP software to log the errors that are shown in the exhibit?
Your ONTAP cluster shows the cluster network errors that are shown in the event log.
What is used by ONTAP software to log the errors that are shown in the exhibit?
Question 3
Click the Exhibit button.
You are installing a new FAS cluster. The management network must be on tagged VLAN 11 for remote administration by a service provider.
Referring to the exhibit, which two ports will allow service provider access to both cluster and node management LIFs? (Choose two.)
You are installing a new FAS cluster. The management network must be on tagged VLAN 11 for remote administration by a service provider.
Referring to the exhibit, which two ports will allow service provider access to both cluster and node management LIFs? (Choose two.)
Question 4
Click the Exhibit button.
Referring to the exhibit, what information is forwarded to syslog after you enter the scripted install commands? (Choose two.)
Referring to the exhibit, what information is forwarded to syslog after you enter the scripted install commands? (Choose two.)
Question 5
You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.
Which statement explains this behavior?
Which statement explains this behavior?