Online Access Free NS0-504 Practice Test

A company has five Windows servers that are dual-attached, four Linux servers that are single attached, and ten dual-attached Solaris servers. The company wants a highly available architecture. A dual controller FAS3100 series with all onboard FC ports connected to the fabric is being proposed. What is the total number of FC ports and what type of fabric should be deployed from the choices shown?

• A.dual fabrics with 42 ports total
• B.dual fabrics with 38 ports total
• C.single fabric with 38 ports total
• D.single fabric with 42 ports total

NetApp storage systems require which information to configure the storage system for management tools? (Choose two.)

• A.Volume options
• B.SnapMirror configuration information
• C.Configuration information for AutoSupport
• D.LUNs being used by clients
• E.IP addresses for e0M

During initial site preparation prior to SAN installation and after ordering is complete, which team's plans are critical to confirm before fabric and storage hardware deployment can begin?

• A.Storage administration: Final volume layout
• B.VMware administration: VM assignment to ESXi hosts
• C.Facilities: Space-planning, power, cooling, cabling
• D.Backup team: Offsite volume replication scheduling

Which three storage features can be scaled by storage administrators? (Choose three.)

• A.capacity scaling, by allowing more than two storage systems to be combined with larger disk shelves
• B.energy scaling, by allowing the cluster to share the same power source
• C.performance scaling, by using Flash Cache, SSDs, and Quality of Service
• D.heterogeneous scaling, by allowing E-Series and FAS-Series systems within a single cluster
• E.network scaling, by providing three or more network switches for the cluster network
• F.operational scaling, by allowing the entire cluster to be administrated through a single resilient interface

A company has FC patch panels in their data center. They plan on using them to interconnect their storage controllers to the FC switches and the hosts using the storage. They have 62.5 micron cable between the patch panels. Which cable should you use on the NetApp storage controller's Target Ports to make this a supported configuration?

• A.long wave SFPs, 50 micron FC cable
• B.short wave SFPs, 50 micron FC cable
• C.long wave SFPs, 62.5 micron FC cable
• D.short wave SFPs, 62.5 micron FC cable