Online Access Free NS0-506 Practice Test

In a 4-node cluster, how many LIFs are required on each node to allow a host to use ALUA and have multiple optimized
paths to each LUN?

• A.1
• B.4
• C.6
• D.2

Which two port personality combinations are valid for the onboard UTA2 ports on a FAS8040 controller?

• A.e0e/0e - fc
  e0f/0f - fc
  e0g/0g - cna
  e0h/0h -cna
• B.e0e/0e - cna
  e0f/0f -cna
  e0g/0g - fc
  e0h/0h - fc
• C.e0e/0e - fc
  e0f/0f - cna
  e0g/0g - fc
  e0h/0h -cna
• D.e0e/0e - fc
  e0f/0f - fc
  e0g/0g - fc
  e0h/0h -cna

You have executed the following FC configuration workflow:
1. Verify IMT supported configuration.
2. Install VSC for VMware vSphere on a Windows Server.
3. Add the storage cluster to VSC and set recommended values.
4. Update host HBA firmware and BIOS.
5. Provision the LUN.
6. Manually create an igroup and add the host WWPNs into it.
7. Map the LUN to the igroup.
8. Create datastore and its containing LUNS and volumes.
In step 8, you are not able to see the LUNs you provisioned on your storage controller. When you run igroup show you
see the ESX host's initiators; however, they are listed "not logged in".
What is the problem?

• A.You need to configure ALU
• B.The LUN type is not set to type VMware.
• C.You need to configure zoning.
• D.The LUN was not put online.

Which objects reside inside an igroup?

• A.volumes
• B.LUNs
• C.qtrees
• D.host initiators

Microsoft ODX supports which scenario on clustered Data ONTAP 8.3?

• A.moving a VHDX from a SAN LUN source to a SAN LUN destination with no SMB support
• B.moving a VHDX from an SMB 3.0 source to an SMB 3.0 destination with no SAN support
• C.moving a VHDX with both SMB 2.1 and SAN protocols as either source or destination
• D.moving a VHDX with both SMB 3.0 and SAN protocols as either source or destination