Online Access Free NS0-527 Practice Test

You want to set up protection relationships at the time of provisioning one or more primary volumes in the source cluster in ONTAP. Which NetApp management tool enables you to accomplish this task?

• A.OnCommand System Manager
• B.OnCommand Unified Manager
• C.ONTAPCLI
• D.SnapCenter

Click the Exhibit button.

You are configuring cluster peering from cluster2 to cluster1 on your ONTAP 9.7 clusters using ONTAP System Manager. You are given the details shown below to set up the cluster peer relationship. You want to determine why the peering has failed.
Cluster2 intercluster LIFIP: 192.168.0.143 Subnet: 255.255.255.0 Port: e0e passphrase: netapp1234 Cluster1 intercluster LIF IP: 192.168.0.153 Subnet: 255.255.255.0 Port: e0e passphrase: netapp1234 Referring to the exhibit, which statement is correct?

• A.The Source Cluster Passphrase is incorrect.
• B.The Target Cluster Passphrase is incorrect.
• C.The Source Cluster IP is incorrect.
• D.The Target Cluster IP is incorrect.

After deploying an ONTAP Select 2 node HA cluster at a remote site, you successfully perform manual takeover and giveback before placing the cluster into production. After the cluster runs in production for a week, you notice that you can no longer perform a manual takeover.
In this scenario, what are two causes of this problem? (Choose two.)

• A.ONTAP Deploy has been deleted.
• B.The vSphere HA service has failed.
• C.The HA interconnect cables have been removed.
• D.There is a network disruption between sites.

A customer has a new cloud strategy. They want to replicate mission-critical SAN volumes to the cloud for DR. Which NetApp technology satisfies the requirement?

• A.Cloud Sync service
• B.Fabric Pool technology
• C.Cloud Volumes Service
• D.Cloud Volumes ONTAP

A customer is using SnapMirror to replicate their data to a remote site. They notice that storage efficiency is nor preserved, and the amount of data at the destination is higher than expected.
In this scenario, which configuration in the destination volume would cause this issue?

• A.Post process deduplication is enabled on the destination.
• B.The volumes are not thin-provisioned onthe destination.
• C.Post process compression is enabled on the destination.
• D.There is an existing FlexClone volume on the destination.