Online Access Free NS0-593 Practice Test

After a normal power down of both nodes for building maintenance, Node01 of a 2-node cluster cannot be powered back up; however, all disk shelves are powered.
Which action should be performed to bring the cluster online and allow Node02 to serve data?

• A.Reboot the node With the system node reboot -node Node02 -bypass-optimization true command.
• B.Perform a takeover with the storage failover takeover -ofnode Node01 -option force command.
• C.Recreate the cluster with the system configuration recovery cluster recreate -from node command.
• D.Reinitialize the cluster with option 4a from the boot menu.

A storage administrator reports that a monitoring toot is reporting that the storage controller reads between 90% to 93% CPU use. You run the sysstat -m command against the node in question.

Referring to the exhibit, which statement is correct?

• A.The CPU Is not a first-order monitoring metric for ONTAP.
• B.You should immediately investigate further by gathering perfstat data and opening a support case.
• C.High network exempt use could be a problem.
• D.The customer should be advised to exclude certain workflows to reduce use.

Your customer installed the shelf firmware for their NS224 shelf over a week ago, and the firmware has not upgraded on shelf 1 module B. The customer wants to know what the next steps would be to get the firmware upgraded after verifying that the shelf firmware is indeed loaded onto the system.
Which step would you perform to complete the firmware upgrade?

• A.Reseat the NSM100 module.
• B.Power cycle the shelf.
• C.Reseat the PSU of the shelf.
• D.Reseat the disk in Bay 0.

The motherboard of Node-01 is being replaced. To perform this task, a takeover was Initiated from Node-02. Node-02 panics showing the string below.
PANIC; Permanent errors on all HA mailbox disks (while marshalling header) in SKprocess fnmbx_instanceWorker on release 9.5P8 (C) What has happened in this situation?

• A.While in maintenance mode, the HA_config show command was executed.
• B.While in maintenance mode, the fcadmin device_map command was executed.
• C.While in maintenance mode, the sldiag device show command was executed.
• D.While in maintenance mode, the mailbox destroy local command was executed.

You Just used the CLI to create a NetApp ONTAP FlexGroup Volume on a NetApp Cloud Volumes ONTAP instance. After creation, you notice odd behavior in NetApp Cloud Manager.
In this scenario, what Is the reason for this behavior?

• A.Cloud Volumes ONTAP does not support FlexGroup volumes.
• B.The Capacity Management Mode within Cloud Manager should be set to Manual.
• C.The Capacity Management Mode within Cloud Manager should be set to Automatic.
• D.Cloud Manager must be used to provision the FlexGroup volume.