Online Access Free NSE6_FSW-7.2 Practice Test

What feature can network administrators use to segment network operations and the administration of managed FortiSwitch devices on FortiGate?

• A.FortiGate clustering protocol
• B.FortiLink split interface
• C.Multi-chassis link aggregation trunk
• D.FortiGate multi-tenancy

Which statement about 802.1X security profiles using MAC-based authentication mode is true?

• A.FortiSwitch performs faster when using this security mode on the ports.
• B.FortiSwitch allows connectivity to all hosts connected to a port, if one host is authenticated.
• C.FortiSwitch must communicate with the RADIUS server to authenticate devices
• D.FortiSwitch can grant each device a different access level based on the credentials provided

Refer to the exhibit.

Core-1 and Access-1 are managed and authorized by FortiGate-1. which uses port4 as the FortiLink interface. After FortiGate authorizes and manages Core-2. Port1 status becomes STP discarding.
Why is port1 in the discarding state?

• A.Core-1 and Core-2 do not have MCLAG configuration.
• B.port1 on Core-2 is discarding only management traffic.
• C.Access-1 is the root bridge and can only have one root port.
• D.Core-2 has the lowest bridge priority.

Exhibit.

port1 and port2 are the only ports configured with the same native VLAN 10.
What are two reasons that can trigger port1 to shut down? (Choose two.)

• A.An endpoint sent a BPDU on port1 that it received from another interface.
• B.STP triggered a loop and applied loop guard protection on port1.
• C.port1 was shut down by loop guard protection.
• D.Loop guard frame sourced from port1 was received on port1.

Refer to the exhibits


Traffic arriving on port2 on FortiSwitch is tagged with VLAN ID 10 and destined for PC1 connected on port1. PC1 expects to receive traffic untagged from port1 on FortiSwitch.
Which two configurations can you perform on FortiSwitch to ensure PC1 receives untagged traffic on port1? (Choose two.)

• A.Add the MAC address of PCI as a member of VLAN 10.
• B.Remove VLAN 10 from the allowed VLANs and add it to untagged VLANs on port1.
• C.Enable Private VLAN on VLAN 10 and add VLAN 20 as an isolated VLAN.
• D.Add VLAN ID 10 as a member of the untagged VLANs on port1.