Online Access Free NSE6_FWF-6.4 Practice Test

Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

• A.Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.
• B.Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility
• C.Areas with the signal strength weaker than -68 dB are cut out of the map
• D.Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor

Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)

• A.DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.
• B.DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.
• C.DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.
• D.DARRP measurements can be scheduled to occur at specific times.

Six APs are located in a remotely based branch office and are managed by a centrally hosted FortiGate.
Multiple wireless users frequently connect and roam between the APs in the remote office.
The network they connect to, is secured with WPA2-PSK. As currently configured, the WAN connection between the branch office and the centrally hosted FortiGate is unreliable.
Which configuration would enable the most reliable wireless connectivity for the remote clients?

• A.Configure a bridge mode wireless network and enable the Local authentication configuration option
• B.Install supported FortiAP and configure a bridge mode wireless network
• C.Configure a bridge mode wireless network and enable the Local standalone configuration option
• D.Configure a tunnel mode wireless network and enable split tunneling to the local network

Which two configurations are compatible for Wireless Single Sign-On (WSSO)? (Choose two.)

• A.A VAP configured to authenticate locally on FortiGate
• B.A VAP configured for WPA2 or 3 Enterprise
• C.A VAP configured to authenticate using a radius server
• D.A VAP configured for captive portal authentication

You are investigating a wireless performance issue and you are trying to audit the neighboring APs in the PF environment. You review the Rogue APs widget on the GUI but it is empty, despite the known presence of other APs.
Which configuration change will allow neighboring APs to be successfully detected?

• A.Enable Monitor channel utilization on the relevant AP profiles.
• B.Ensure that all allowed channels are enabled for the AP radios.
• C.Enable Radio resource provisioning on the relevant AP profiles.
• D.Enable Locate WiFi clients when not connected in the relevant AP profiles.