Online Access Free NSE6_SDW_AD-7.6 Practice Test

When you use the command diagnose sys session list, how do you identify the sessions that correspond to traffic steered according to SD-WAN rules?

• A.You identify sessions steered according to SD-WAN rules with the data vwl_mbr_seq.
• B.You identify sessions steered according to SD-WAN rules with the flag vwl.
• C.You identify sessions steered according to SD-WAN rules with the data sdwan_service_id.
• D.You cannot identify SD-WAN sessions. You must use the sdwar. session filter.

Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

• A.The session information output displays no SD-WAN-specific details.
• B.Traffic does not match any of the entries in the policy route table.
• C.Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
• D.All SD-WAN rules have the default and gateway setting enabled.

Refer to the exhibit. The exhibit shows the health-check configuration on a FortiGate device used as a spoke. You notice that the hub FortiGate doesn't prioritize the traffic as expected.
Which two configuration elements should you check on the hub? (Choose two.)

• A.This performance SLA uses the same members.
• B.The performance SLA is configured with set embedded-measure accept.
• C.The performance SLA has the parameter priority-out-slaconfigured.
• D.The performance SLA uses the same criteria.

Refer to the exhibit, which shows the SD-WAN rule status and configuration.

Based on the exhibit, which change in the measured latency will first make HUB1-VPN3 the new preferred member?

• A.When HUB1-VPN3 has a latency of 90 ms
• B.When HUB1-VPN1 has a latency of 200 ms
• C.When HUB1-VPN3 has a latency of 80 ms
• D.When HUB1-VPN3 has a lower latency than HUB1-VPN1 and HUB1-VPN2

Refer to the exhibit that shows a diagnose output on a FortiGate device.

Based on the output shown in the exhibit, what can you conclude about the device role and how it handles health checks?

• A.The device is a spoke and it provides embedded health-check measures for each tunnel to the hub.
• B.The device is a spoke and it receives health-check measures for the tunnels of another spoke.
• C.The device is a hub and it receives health-check measures for the tunnels of a spoke.
• D.The device is a hub and it receives embedded health-check measures for each tunnel from the spoke.