Online Access Free NSE7_EFW Practice Test

Examine the output of the 'diagnose ips anomaly list' command shown in the exhibit; then answer the question below.

Which IP addresses are included in the output of this command?

• A.Those whose traffic exceeded a threshold of a matching DoS policy.
• B.Those whose traffic was detected as an anomaly by an IPS sensor.
• C.Those whose traffic matches a DoS policy.
• D.Those whose traffic matches an IPS sensor.

Examine the output from the BGP real time debug shown in the exhibit, then the answer the question below:

Which statements are true regarding the output in the exhibit? (Choose two.)

• A.The state of the remote BGP peer is OpenConfirm.
• B.The state of the remote BGP peer will go to Connect after it confirms the received prefixes.
• C.Local BGP peer received a prefix for a default route.
• D.BGP peers have successfully interchanged Open and Keepalive messages.

View the exhibit, which contains an entry in the session table, and then answer the question below.

Which one of the following statements is true regarding FortiGate's inspection of this session?

• A.FortiGate forwarded this session without any inspection.
• B.FortiGate applied flow-based inspection.
• C.FortiGate applied explicit proxy-based inspection.
• D.FortiGate applied proxy-based inspection.

An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP. The output of the debug flow is shown in the exhibit:

Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)

• A.The packet is denied because of reverse path forwarding check.
• B.HTTP administrative access is disabled in the FortiGate interface with the IP address 10.0.1.254.
• C.Redirection of HTTP to HTTPS administrative access is disabled.
• D.HTTP administrative access is configured with a port number different than 80.

A FortiGate is rebooting unexpectedly without any apparent reason. What troubleshooting tools could an administrator use to get more information about the problem? (Choose two.)

• A.Firewall monitor.
• B.Policy monitor.
• C.Crashlogs.
• D.Logs.