A.FEC transmits additional packets as redundant data to the remote device.

B.FEC is useful to increase speed at which traffic is routed through IPsec tunnels.

C.FEC improves reliability which overcomes adverse WAN conditions such as noisy links.

D.FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss

E.FEC transmits the original payload in full to recover the error in transmission.

A.It enables the SD-WAN rule to load balance and assign traffic with a route tag

B.It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.

C.It tags each route and references the tag in the routing table.

D.It ensures route tags match the SD-WAN rule based on the rule order

A.Select SD-WAN balancing strategy.

B.Specify outgoing interface routing cost.

C.Specify incoming interfaces in SD-WAN rules.

D.Configure SD-WAN rules interface preference.

A.This traffic shaper drops traffic that exceeds the set limits.

B.Traffic being controlled by the traffic shaper is under 1 Kbps.

C.FortiGate provides statistics and reading based on historical traffic logs.

D.The debug output shows per-IP shaper values and real-time readings.

A.100.64.3.1 is one of the remote IP address that comes through index interface 1.

B.FortiGate created a single IPsec virtual interface that is shared by all clients.

C.There are separate virtual interfaces for each dial-up client.

D.VPN static routes are prevented from populating the FortiGate routing table.