Free Access Fortinet.NSE7_SDW-7.2.v2024-11-26.q94 Practice Test (Page 19)

Question 86

Refer to the exhibit.

Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?

A.All traffic from a source IP to a destination IP is sent to the same interface.

B.All traffic from a source IP is sent to the same interface.

C.All traffic from a source IP is sent to the most used interface.

D.All traffic from a source IP to a destination IP is sent to the least used interface.

Question 87

What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

A.FortiGate has obtained a configuration from the platform template in FortiGate cloud.

B.A factory reset performed on FortiGate.

C.The zero-touch provisioning process has completed internally, behind FortiGate.

D.FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

E.The FortiGate cloud key has not been added to the FortiGate cloud portal.

Question 88

Exhibit.

Which conclusion about the packet debug flow output is correct?

A.The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions
configured in the traffic shaper, and the packet was dropped.

B.The packet size exceeded the outgoing interface MTU.

C.The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions
configured in the traffic shaper, and the packet was dropped.

D.The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions
configured in the firewall policy, and the packet was dropped.

Question 89

Refer to the exhibits.

Exhibit A shows two IPsec templates to define Branch_IPsec_1 and Branch_IPsec_2. Each template defines a VPN tunnel.
Exhibit B shows the error message that FortiManager displayed when the administrator tried to assign the second template to the FortiGate device.
Which statement best explain the cause for this issue?

A.You can assign only one template with a tunnel of fype static to each FortiGate device

B.You can define only one IPsec tunnel from branch devices to HUB1.

C.You can assign only one IPsec template to each FortiGate device.

D.You should review the branch1_fgt configuration for the already configured tunnel with the name HUB1-VPN2.

Question 90

Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

A.The number of simultaneous connections allowed for each source IP address cannot exceed five
connections.

B.The number of simultaneous connections among all source IP addresses cannot exceed five connections.

C.The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

D.The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

Other Version: 1743Fortinet.NSE7_SDW-7.2.v2025-10-01.q108; 2366Fortinet.NSE7_SDW-7.2.v2025-03-01.q95; 1203Fortinet.NSE7_SDW-7.2.v2024-09-17.q87

Latest Upload: 202PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 299Nokia.4A0-113.v2026-05-01.q69; 255EC-COUNCIL.312-49v11.v2026-04-30.q214; 228Microsoft.MB-820.v2026-04-30.q101; 211Salesforce.MC-202.v2026-04-30.q57; 206BICSI.INSTC_V8.v2026-04-29.q53; 335NMLS.MLO.v2026-04-28.q82; 243NCARB.Project-Management.v2026-04-28.q27; 462EMC.D-AV-DY-23.v2026-04-27.q184; 1116ServiceNow.CSA.v2026-04-27.q483

Question 86

Question 87

Question 88

Question 89

Question 90

Download PDF File