Online Access Free RF0-001 Practice Test

In a conveyor application, which of the following would be MOST important for getting consistent reads?

• A.Slowing down the conveyor until the read rate is acceptable.
• B.Angling the antennas to increase the time the tag is in the interrogation zone.
• C.Adding an additional interrogator to increase coverage.
• D.Speeding up the conveyor.

An RFID system is to be used in a conveyor belt operation where single boxes with RFID labels are to be read. Which of the following types of antennas would be MOST effective?

• A.Circularly polarized
• B.Horizontally polarized linear
• C.Isotropic
• D.Vertically polarized linear

When installing equipment into a proposed interrogation zone based on the site diagram, a technician observes that the cooling fans at the dock doors are directly in the way of the dock stands requiring installation. Which of the following actions should the technician take?

• A.Contact the project manager to arrange a meeting with site management and determine the best solution.
• B.Remove the fans and place them on the floor just outside of the proposed interrogation zone.
• C.Remove the fans; install the dock stands, and then remount the fans to the dock stands to complete the job.
• D.Cancel the installation because there are physical constraints preventing them from completing the job as designed.

All of the following help solve multiple interrogator environment issues EXCEPT:

• A.using absorptive material.
• B.single side band modulation.
• C.using multi-protocol interrogators.
• D.separate transmit and receive channels.

Which of the following is the maximum output power of the interrogator at the connector between the interrogator and the antenna according to Federal Communication Commission (FCC) rules for 902-928 MHz RFID?

• A.100 milliwatts
• B.One watt
• C.500 milliwatts
• D.4 watts