Explanation
This is the most likely cause of the issue because firewall rules can block or allow traffic based on source, destination, port, protocol, or other criteria. If the firewall rules are not configured properly, they can prevent remote users from accessing the cloud application server, while allowing on-site users to access it. References:
https://docs.microsoft.com/en-us/azure/virtual-network/security-overview

The technician should configure RAID 6 for this drive array to meet the server specifications. RAID 6 is a type of RAID level that provides fault tolerance and performance enhancement by using striping and dual parity. Striping means dividing data into blocks and distributing them across multiple disks to increase speed and capacity. Parity means calculating and storing extra information that can be used to reconstruct data in case of disk failure. RAID 6 uses two sets of parity information for each stripe, which are stored on different disks. This way, RAID 6 can handle up to two disk failures without losing any data or functionality. RAID 6 also allows for the least amount of drive space lost to RAID overhead compared to other RAID levels that can handle two disk failures, such as RAID 1+0 or RAID 0+1.

The most likely cause of the internet issue is B. The DHCP scope is full.
A DHCP scope is a range of IP addresses that a DHCP server can assign to DHCP clients on a network. A DHCP scope has a start address and an end address, and it can also have some excluded addresses that are not available for lease. A DHCP scope can have various options, such as subnet mask, default gateway, DNS server, etc., that are applied to the DHCP clients along with the IP address. A DHCP scope also has a lease time, which is the duration that a DHCP client can use an IP address before renewing it or releasing it. A DHCP scope can have reservations, which are fixed IP addresses that are assigned to specific DHCP clients based on their MAC addresses12 If a DHCP scope is full, it means that there are no more IP addresses available for lease in the scope. This can happen if the number of DHCP clients exceeds the number of IP addresses in the scope, or if the lease time is too long and the IP addresses are not released or reused frequently enough. If a DHCP scope is full, any new or existing DHCP clients that request an IP address from the DHCP server will not receive one, and they will not be able to access the network or the internet12 In this scenario, users are able to connect to the wireless network, but they are unable to access the internet.
The network administrator verifies connectivity to all network devices, and there are no ISP outages. The server administrator removes the old address leases from the active leases pool, which allows users to access the internet. This indicates that the DHCP scope is full, and that removing the old leases frees up some IP addresses for lease in the scope. Therefore, option B is the most likely cause of the internet issue.