Explanation
The administrator is attempting to establish the recovery point objective (RPO) by determining how frequently backups need to be performed on an application server. RPO is a metric that defines how much data can be lost or how far back in time a recovery can go in case of a disaster or disruption, based on the business requirements and impact analysis of an organization or system. RPO is measured by the time interval between backups or snapshots of data, such as hourly, daily, weekly, etc., depending on how critical or sensitive the data is and how often it changes or updates. References: [CompTIA Server+ Certification Exam Objectives], Domain 5.0: Security, Objective 5.3: Given a scenario, explain methods and techniques to secure data.

* The ping command output shows that the NIC has an IP address of 192.168.1.100 and a default gateway of 192.168.1.1. However, when the technician tries to ping the default gateway, the reply comes from another IP address: 192.168.1.101. This means that there is another device on the network that has the same IP address as the default gateway, and it is responding to the ping request instead of the intended destination.
* A duplicate IP address can cause network connectivity problems, such as packet loss, routing errors, or unreachable hosts. To resolve this issue, the technician should either change the IP address of the default gateway or the device that is conflicting with it, or use DHCP to assign IP addresses automatically and avoid conflicts.
* The other options are not correct because they do not explain the ping output. An incorrect default gateway would cause no reply or a destination unreachable message, not a reply from a different IP address. A DHCP misconfiguration would cause an invalid or no IP address on the NIC, not a duplicate IP address on the network. An incorrect routing table would cause routing errors or unreachable destinations, not a reply from a different IP address.
References:
* https://askleo.com/what_is_ping_and_what_does_its_output_tell_me/
* https://learn.microsoft.com/en-us/windows-server/administration/windows-commands/ping

The administrator should use 172.16.19.241 as an IP address to be in compliance with RFC 1918 standard.
RFC 1918 defines three ranges of IP addresses that are reserved for private internets, meaning they are not globally routable on the public Internet and can be used within an enterprise without any risk of conflict or overlap with other networks. These ranges are:
10.0.0.0 - 10.255.255.255 (10/8 prefix) 172.16.0.0 - 172.31.255.255 (172.16/12 prefix) 192.168.0.0 -
192.168.255.255 (192.168/16 prefix)
Out of these ranges, only 172.16.19.241 falls within one of them (172.16/12 prefix). The other options are either public IP addresses that belong to other organizations or networks (11.251.196.241, 171.245.198.241) or invalid IP addresses that do not conform to any standard (193.168.145.241).

Open-source software is software that is freely available and can be modified and distributed by anyone. It usually requires very little technical support and has no licensing fees. Therefore, it would be the lowest cost solution for an application that does not need much support. References:
https://www.comptia.org/training/resources/exam-objectives/comptia-server-sk0-005-exam-objectives (Objective 2.3)

1. Mailrelay - Keep the mail relay on the existing Rack1 and change the primary power supply to PDU-B and Failover powersupply as PDU B.
2. Move the VM Host 1 and VM Host2 to Rack2.
Assign primary power supply PDU A to VM host1
Assign Failover power supply PDU B to VM host1
Assign primary power supply PDU B to VM host2
Assign Failover power supply PDU A to VM host2