Online Access Free ST0-247 Practice Test

The failover service group named websg is FROZEN and is ONLINE/PARTIAL in a two-node cluster. The power is unplugged from the system on which websg is ONLINE/PARTIAL.
Consider the configuration file below:
group wewbsg (
SystemList = { sym1 = 1, sym2 = 2 }
AutoFailover = 1
AutoStartList = { sym1, sym2 }
Parallel = 0)
What will be the state of websg on the surviving system?

• A.FROZEN
• B.ONLINE/PARTIAL
• C.OFFLINE
• D.AutoDisabled

Refer to the exhibit.

A two-node cluster has three failover service groups as shown in the exhibit. The websg and appsg service groups are online on sym1 the dbsg service group is online on sym2. All resources are enabled and critical.
Which action does Veritas Cluster Server take when a resource in the appsg service group faults?

• A.The appsg service group enters a faulted state on sym1, and the dbsg service group is taken offline.
• B.The appsg service group enters a faulted state on sym1 and fails over to sym2.
• C.The appsg service group enters a faulted state on sym1, and the websg service group is taken offline.
• D.The appsg service group enters a faulted state, and the websg service group remains online.

Which statement is true about using the hares -override CSGNIC MonitorInterval command?

• A.It must be changed for the Resource Type.
• B.It sets MonitorInterval for CSGNIC to 0.
• C.It allows setting MonitorInterval for CSGNIC.
• D.It must be set in the TypeDefaults.cf.

What does freezing a service group prevent?

• A.Online and offline operations in the service group
• B.VCS notification of faults in the service group
• C.Monitoring of VCS resources in the service group
• D.Modification of resource attributes in the service group

You are adding a system to a running cluster. You have successfully performed these steps on the system that you are adding:
1.Installed, configured, and tested all application resources required
2.Installed VCS
3.Configured and started VCS communications (LLT and GAB)
What is the next step that you perform?

• A.Update the resource attributes to enable resources to run on the new system
• B.Change the owner of the system attributes so that all cluster systems are the same
• C.Update the service group attributes to enable groups to run on the new system
• D.Change the cluster attribute for VCS user names to match accounts on the new system