Online Access Free VCS-276 Practice Test

A tape library had the robot firmware upgraded and now the robot is reading the barcodes with additional characters.
How should an administrator enable NetBackup 8.0to use the same characters as before the firmware upgrade occurred?

• A.update the Media ID Generation setting
• B.update the Barcode Rules setting
• C.update Device mappings
• D.update Media settings

Backups to a storage device fail with the following error message:
Disk storage is down (2106)
The storage server is an OpenStorage (OST) host, and the Master Server and Media Server are both acting as Media Servers under Credentials > Storage Servers in the Administration Console. The disk pool is in an Up state and the storage server is in a Down state. Troubleshooting confirmed the OST plug-ins on the servers are mismatched.
Which command should an administrator use to check the plug-in version installed on the servers?

• A.nbdevquery
• B.nbftconfig
• C.bpgetconfig
• D.bpstsinfo

How can an administrator determine the storage and database paths for a Media Server Deduplication Pool?

• A.view Storage Server > Properties for the storage server
• B.run the Configure Disk Storage Server wizard for the MSDP
• C.view Storage Unit > View Properties for the MSOP storage unit
• D.view Disk Pool > Disk volumes for the MSDP disk pool

Refer to the exhibit.

What is the outcome of the policy shown in the exhibit?

• A.The client compresses then encrypts the data before sending it to the Media Server.
• B.The client compresses and the Media Server encrypts the data before sending it to the tape drive.
• C.The client sends the data to the Media Server, which compresses and then encrypts the data.
• D.The client encrypts then compresses the data before sending it to the Media Server.

An administrator has a scheduled policy has a scheduled policy backs up 20 clients, each with multiple mount points and multiple data streams enabled. One of the jobs has failed and is in an Incomplete slate in the Activity Monitor.
Mow should the administrator verify the incomplete job runs prior to the next scheduled backup?

• A.resume the job
• B.run a manual job for the mount point
• C.resume the parent job
• D.run a manual job the client