The command that will allow the technician to execute the services and continue deploying other microservices within the same terminal session is bg %1 job name. This command will send the job with ID 1 and name job name to the background, where it will run without occupying the terminal. The other options are incorrect because:
gedit & disown will launch a graphical text editor in the background and detach it from the terminal, but it will not execute any service.
kill 9 %1 will terminate the job with ID 1 using a SIGKILL signal, which cannot be ignored or handled by the process.
fg %1 will bring the job with ID 1 to the foreground, where it will occupy the terminal until it finishes or is stopped. Reference: CompTIA Linux+ Study Guide, Fourth Edition, page 181-182.

Explanation
The systemctl reboot command will restore the server to its usual target by rebooting it. This will cause the server to load the default target specified in /etc/systemd/system.conf or /etc/systemd/system/default.target files. The telinit 0 command would shut down the server, not restore it to its usual target. The systemctl get-default command would display the default target, not change it. The systemctl emergency command would switch the server to emergency.target mode, which is even more restrictive than rescue.target mode. References: [CompTIA Linux+ (XK0-005) Certification Study Guide], Chapter 17: System Maintenance and Operation, page 516.

The issue is caused by the server 192.168.168.53 being unreachable. This server is the DNS server configured in the /etc/resolv.conf file, which is used to resolve domain names to IP addresses. The ping command shows that the server cannot be reached, and the nslookup command shows that the name www.comptia.org cannot be resolved using this server. The other options are incorrect because:
The name www.comptia.org does point to a valid IP address, as shown by the nslookup command using another DNS server (8.8.8.8).
The default route is set on the server, as shown by the ip route command, which shows a default gateway of 192.168.168.1.
The network interface eth0 is connected, as shown by the ip link command, which shows a state of UP for eth0. Reference: CompTIA Linux+ Study Guide, Fourth Edition, page 457-458, 461-462.