The command that will permanently resolve the issue of high CPU load and average is kill -9 6295. This command will send a SIGKILL signal to the process with the PID 6295, which is the process that is consuming 99.7% of the CPU according to the top output. The SIGKILL signal will terminate the process immediately and free up the CPU resources. The kill command is used to send signals to processes by PID or name.
The other options are not correct commands for resolving this issue. The renice -n -20 6295 command will change the priority (niceness) of the process with PID 6295 to -20, which is the highest priority possible. This will make the process more CPU-intensive, not less. The renice command is used to change the priority of running processes. The pstree -p 6295 command will show a tree of processes with PID 6295 as the root. This will not affect the CPU load or average, but only display information. The pstree command is used to display a tree of processes. The iostat -cy 1 5 command will show CPU and disk I/O statistics for 5 iterations with an interval of 1 second. This will also not affect the CPU load or average, but only display information. The iostat command is used to report CPU and I/O statistics. References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 11: Troubleshooting Linux Systems; kill(1) - Linux manual page; renice (1) - Linux manual page; pstree(1) - Linux manual page; iostat(1) - Linux manual page

To mirror the website files on the primary web server, www1, to the backup web server, www2, the administrator can use the command rsync -a -e ssh /var/www/html/ user1@www2:/var/www/html (A). This will synchronize all files and directories under
/var/www/html/ on www1 to /var/www/html on www2 using ssh as the remote shell. The - a option will preserve all attributes and permissions of the files.

The server's firewall is preventing connections from being made, which is causing the connectivity issue. The output of iptables -L -n shows that the firewall is blocking all incoming traffic on port 22, which is the default port for SSH. The output of ssh -v [email protected] shows that the connection is refused by the server. To resolve the issue, the administrator needs to allow port 22 on the firewall. The other options are incorrect because they are not supported by the outputs. The workstation has the correct IP settings, as shown by the output of ip addr show. The sshd service is enabled and running, as shown by the output of systemct1 status sshd. The server has the correct default gateway configuration, as shown by the output of ip route show. References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 13: Managing Network Services, pages 406-407.

The issue is caused by the lack of a default route defined in the /etc/sysconfig/network-scripts/ifcfg-enp0s3 file. A default route is a special route that specifies where to send packets that do not match any other routes in the routing table. Without a default route, the server will not be able to communicate with hosts outside its local network. The default route is usually configured with the GATEWAY option in the network interface configuration file. For example, to set the default gateway to 192.168.1.1, the file should contain:
GATEWAY=192.168.1.1
The other options are not causing the issue. The DNS address is not commented out in the configuration file, it is specified with the DNS1 option. The search entry in the /etc/resolv.conf file is correct, it specifies the domain name to append to unqualified hostnames. Wired connection 1 is online, as indicated by the ONBOOT=yes option and the output of ip link show enp0s3 command. References: Configuring IP Networking with nmcli; Configuring IP Networking with ifcfg Files