Question 36
Which parameter indicates the number of current users logged on to the Citrix gateway?
Question 37
Scenario: A Citrix Architect needs to deploy a NetScaler appliance for Workspacelab, which will provide application load balancing services to Partnerlab and Vendorlab.
The setup requirements are as follows:
* A pair of NetScaler MPX appliances will be deployed in the DMZ network.
* High availability will be accessible on the NetScaler MPX in the DMZ Network.
* Load balancing should be performed for the mail servers for Partnerlab and Vendorlab.
* The traffic for both of the organizations must be isolated.
* Separate Management accounts must be available for each client.
* The load-balancing IP addresses must be identical.
* A separate VLAN must be utilized for communication for each client.
Which solution can the architect utilize to meet the requirements?
The setup requirements are as follows:
* A pair of NetScaler MPX appliances will be deployed in the DMZ network.
* High availability will be accessible on the NetScaler MPX in the DMZ Network.
* Load balancing should be performed for the mail servers for Partnerlab and Vendorlab.
* The traffic for both of the organizations must be isolated.
* Separate Management accounts must be available for each client.
* The load-balancing IP addresses must be identical.
* A separate VLAN must be utilized for communication for each client.
Which solution can the architect utilize to meet the requirements?
Question 38
Scenario: A Citrix Engineer is asked by management at the workspacelab organization to review their existing Citrix ADC Configurations and make the necessary upgrades. The architect recommends small changes to the pre-existing Citrix ADC configuration. Currently, the Citrix ADC MPX devices are configured in high-availability pair, and the outbound traffic is load balanced between two internet service providers (ISPs), however, the failover is NOT happening correctly. The following requirements were discussed during the design requirement phase:
* The return traffic for a specific flow should be routed through the same path while using Link Load Balancing.
* The link should fail over even if the ISP router is up and intermediary devices to an ISP router are down.
* Traffic going through one ISP router should fail over to the secondary ISP, and the traffic should not flow through both routers simultaneously.
What should the architect configure with Link Load Balancing LLB) to meet the requirement?
* The return traffic for a specific flow should be routed through the same path while using Link Load Balancing.
* The link should fail over even if the ISP router is up and intermediary devices to an ISP router are down.
* Traffic going through one ISP router should fail over to the secondary ISP, and the traffic should not flow through both routers simultaneously.
What should the architect configure with Link Load Balancing LLB) to meet the requirement?
Question 39
Which two settings should a Citrix Architect use on Citrix Application Delivery Management for configuring CPX using a pre-existing CPX device? (Choose two.)
Question 40
Which encoding type can a Citrix Architect use to encode the StyleBook content, when importing the StyleBook configuration under source attribute?