Question 11
Refer to Exhibit.

The loopback1 interface of the Atlanta router must reach the loopback3 interface of the Washington router.
Which two static host routes must be configured on the NEW York router? (Choose two)

The loopback1 interface of the Atlanta router must reach the loopback3 interface of the Washington router.
Which two static host routes must be configured on the NEW York router? (Choose two)
Question 12
Refer to the exhibit.

The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another?
(Choose two.)

The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another?
(Choose two.)
Question 13
Which set of action satisfy the requirement for multifactor authentication?
Question 14
Refer to the exhibit. A network administrator must permit traffic from the 10.10.0.0/24 subnet to the WAN on interlace Seria10.
What is the effect of the configuration as the administrator applies the command?

What is the effect of the configuration as the administrator applies the command?

Question 15
Refer to the exhibit. All traffic enters the CPE router from interface Serial0/3 with an IP address of
192.168.50.1. Web traffic from the WAN is destined for a LAN network where servers are load- balanced. An IP packet with a destination address of the HTTP virtual IP of 192.168.1.250 must be forwarded. Which routing table entry does the router use?

192.168.50.1. Web traffic from the WAN is destined for a LAN network where servers are load- balanced. An IP packet with a destination address of the HTTP virtual IP of 192.168.1.250 must be forwarded. Which routing table entry does the router use?
