Free Access Cisco.200-301.v2024-12-17.q416 Practice Test (Page 6)

Question 21

What causes a port to be placed in the err-disabled state?

A.port security violation

B.latency

C.nothing plugged into the port
This mode is the default violation mode; when in this mode, the switch will automatically force the switchport into an error disabled (err-disable) state when a violation occurs. While in this state, the switchport forwards no traffic. The switchport can be brought out of this error disabled state by issuing the errdisable recovery cause CLI command or by disabling and reenabling the switchport.

D.shutdown command issued on the port

Question 22

Drag and drop to the characteristics of networking from the left onto the correct networking types on the right.

Question 23

What is a requirement when configuring or removing LAG on a WLC?

A.The incoming and outgoing ports for traffic flow must be specified if LAG is enabled.

B.The controller must be rebooted after enabling or reconfiguring LAG.

C.The management interface must be reassigned if LAG disabled.

D.Multiple untagged interfaces on the same port must be supported.

Question 24

A network administrator must to configure SSH for remote access to router R1 The requirement is to use a public and private key pair to encrypt management traffic to and from the connecting client.
Which configuration, when applied, meets the requirements?

A.Option D

B.Option C

C.Option B

D.Option A

Question 25

Refer to the exhibit.

An IP subnet must be configured on each router that provides enough addresses for the number of assigned hosts and anticipates no more than 10% growth for now hosts. Which configuration script must be used?