Free Access Cisco.200-301.v2024-12-17.q416 Practice Test (Page 8)

Question 31

Drag the IPv6 DNS record types from the left onto the description on the right.

Question 32

Drag and Drop Question
Drag and drop the WLAN components from the left onto the component details on the right.

Question 33

Refer to the exhibit. If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command, how does the router respond?

A.It ignores the new static route until the existing OSPF default route is removed

B.It immediately replaces the existing OSPF route in the routing table with the newly configured static route

C.It starts load-balancing traffic between the two default routes

D.It starts sending traffic without a specific matching entry in the routing table to Gigabit EthernetO/1

Question 34

Refer to the exhibit.

An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.

Question 35

A Cisco engineer must configure a single switch interface to meet these requirements
* accept untagged frames and place them in VLAN 20
* accept tagged frames in VLAN 30 when CDP detects a Cisco IP phone
Which command set must the engineer apply?