Drag and drop the statements about networking from the left onto the corresponding networking types on the right.

Refer to the exhibit Router R1 Fa0/0 is unable to ping router R3 Fa0'1. Which action must be taken in router R1 to help resolve the configuration issue?

Drag and Drop Question
Drag and drop the application protocols from the left onto the transport protocols that is uses on the right.
Select and Place:

Which two actions influence the EIGRP route selection process? (Choose two)

Lab Simulation 24
Guidelines
This is a lab item in which tasks will be performed on virtual devices.
- Refer to the Tasks tab to view the tasks for this lab item.
- Refer to the Topology lab to access the device console(s) and perform the tasks.
- Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
- All necessary preconfigurations have been applied.
- Do not change the enable password or hostname for any device.
- Save your configurations to NVRAM before moving to the next item.
- Click Next at the bottom of the screen to submit this lab and move to the next question.
- When Next is clicked, the lab closes and cannot be reopened.
Topology

Tasks
R1 has been pre-configured with all the necessary commands. All physical cabling is in place and verified. Connectivity to the end devices must be configured.
1. Configure SW-1 switch port 0/1 to carry traffic for the Cisco IP phone and PC
2. Configure SW-2 E0/1 to carry traffic for PC2
3. Configure VLAN 10 with the name "Engineering" on SW-1
4. Configure the link between SW-1 and SW-2 to use the vendor neutral neighbor discovery protocol
5. Configure the link on SW-1 to R1 so that it does not allow the Cisco neighbor discovery protocol to pass