Explanation/Reference:
Explanation:
The command "clear ipv6 ospf" will clear the present routing table and force the OSPFv3 process to build a new one. This command is often used when something in the network was changed or for debugging purpose.
When the "process" keyword is added, which means "clear ipv6 ospf process", the OSPF database is cleared and repopulated then the SPF algorithm is performed.

This router demonstrates an example of an IPv6 Dual Stack configuration. Dual stack (Figure 1 below) runs both IPv4 and IPv6 protocol stacks on a router in parallel, making it similar to the multiprotocol network environments of the past, which often ran Internetwork Packet Exchange (IPX), AppleTalk, IP, and other protocols concurrently. The technique of deploying IPv6 using dual-stack backbones allows IPv4 and IPv6 applications to coexist in a dual IP layer routing backbone. The IPv4 communication uses the IPv4 protocol stack, and the IPv6 communication uses the IPv6 stack.
As a transition strategy, dual stack is ideal for campus networks with a mixture of IPv4 and IPv6 applications.
Figure 1: Dual-Stack Example

See the Explanation below.
Explanation
We need to configure policy based routing to send specific traffic along a path that is different from the best path in the routing table.
Here are the step by Step Solution for this:
1) First create the access list that catches the HTTP traffic:
R1(config)#access-list 101 permit tcp any any eq www
2) Configure the route map that sets the next hop address to be ISP1 and permits the rest of the traffic:
R1(config)#route-map pbr permit 10
R1(config-route-map)#match ip address 101
R1(config-route-map)#set ip next-hop 10.1.100.2
R1(config-route-map)#exit
R1(config)#route-map pbr permit 20
3) Apply the route-map on the interface to the server in the EIGRP Network:
R1(config-route-map)#exit
R1(config)#int fa0/1
R1(config-if)#ip policy route-map pbr
R1(config-if)#exit
R1(config)#exit
First you need to configure access list to HTTP traffic and then configure that access list. After that configure the route map and then apply it on the interface to the server in EIGRP network.