Free Access Cisco.300-410.v2023-04-25.q268 Practice Test (Page 11)

Question 46

Refer to the exhibit.

An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen. What is the reason for this?

A.The metric of the OSPF route is lower than the metric of the static route.

B.The syntax of the static route is not valid, so the route is not considered.

C.The configured AD for the static route is higher than the AD of OSPF.

D.Dynamic routing protocols always have priority over static routes.

Question 47

Refer to the exhibit.

The Internet traffic should always prefer Site-A ISP-1 if the link and BGP connection are up; otherwise, all Internet traffic should go to ISP-2 Redistribution is configured between BGP and OSPF routing protocols and it is not working as expected. What action resolves the issue?

A.Set metric-type 2 at Site-A RTR1, and set metric-type 1 at Site-B RTR2

B.Set OSPF cost 100 at Site-A RTR1, and set OSPF Cost 200 at Site-B RTR2

C.Set OSPF cost 200 at Site: A RTR1 and set OSPF Cost 100 at Site-B RTR2

D.Set metric-type 1 at Site-A RTR1, and set metric-type 2 at Site-B RTR2

Question 48

After some changes in the routing policy, it is noticed that the router in AS 45123 is being used as a transit AS router for several service provides. Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors?
A)