Free Access Cisco.300-410.v2025-02-03.q609 Practice Test (Page 26)

Question 121

Refer to the exhibit. An engineer must redistribute networks 192.168.10.0/24 and
192.168.20.0/24 into OSPF from EIGRP. Where the metric must be added when traversing through multiple hops to start an external route of 20. The engineer notices that the external metric is fixed and does not add at each hop. Which configuration resolves the issue?

A.R2(config)#access-list 10 permit 192.168.10.0 0.0.0.255
R2(config)#access-list 10 permit 192.168.20.0 0.0.0.255 !
R2(config)#route-map RD permit 10
R2(config-route-map)#match ip address 10
R2(config-route-map)#set metric 20
R2(config-route-map)#set metric-type type-1 !
R2(config)#router ospf 10
R2(config-router)#redistribute eigrp 10 subnets route-map RD

B.R2(config)#access-list 10 permit 192.168.10.0 0.0.0.255
R2(config)#access-list 10 permit 192.168.20.0 0.0.0.255 !
R2(config)#route-map RD permit 10
R2(config-route-map)#match ip address 10
R2(config-route-map)#set metric 20
R2(config-route-map)#set metric-type type-2 !
R2(config)#router ospf 10
R2(confjg-router)#redistribute eigrp 10 subnets route-map RD

C.R1(config)#access-list 10 permit 192.168.10.0 0.0.0.255
R1(config)#access-list 10 permit 192.168.20.0 0.0.0.255 !
R1(config)#route-map RD permit 10
R1(config-route-map)#match ip address 10
R1(config-route-map)#set metric 20
R1(config-route-map)#set metric-type type-2 !
R1(config)#router ospf 10
R1(config-router)#redistribute eigrp 10 subnets route-map RD

D.R1(config)#access-list 10 permit 192.168.10.0 0.0.0.255
(config)#access-list 10 permit 192.168.20.0 0.0.0.255 !
R1(config)#route-map RD permit 10
R1(config-route-map)#match ip address 10
R1(config-route-map)#set metric 20
R1(config-route-map)#set metric-type type-1 !
R1(config)#router ospf 10
R1(config-router)#redistribute eigrp 10 subnets route-map RD

Question 122

Refer to the exhibit. An engineer examines the BGP update for the IPv6 prefix 2001:db8::1/128. which should have been summarized into a /64 prefix. Which sequence of actions achieves the summarization?

A.R1 is a route reflector client of a RR with a router ID of 1.1.1.1. and the originator of the prefix has a router ID of 3.3.3.3. Both routers belong to different ASs. The prefix is not advertised to any peer and must be advertised using the network statement on R3.

B.R1 is a route reflector with a router ID of 3.3.3.3. and the originator of the prefix is a route reflector client, which has a router ID of 3.3.3.3. Both routers belong to the same AS Configure an aggregate address on the router with ID 1.1.1.1 for the prefix

C.R1 is a route reflector client of a RR with a router ID of 1.1.1.1. and the originator of the prefix has a router ID of 3.3.3.3. Both routers belong to the same AS. Configure an aggregate address on the router with ID 3 3.3.3 for the prefix.

D.R1 is a route reflector with a router ID of 1.111. and the originator of the prefix is a route reflector client, which has a router ID of 3.3.3.3. Both routers belong to the same AS Configure an aggregate address on the router with ID 1.1.1.1 for the prefix

Question 123

Refer to the exhibit.

A network administrator is discovering a Cisco Catalyst 9300 and a Cisco WLC 3504 in Cisco DNA Center.
The Catalyst 9300 is added successfully However the WLC is showing [ error "uncontactable" when the administrator tries to add it in Cisco DNA Center. Which action discovers WLC in Cisco DNA Center successfully?

A.Copy the .cert file from the Cisco DNA Center on the USB and upload it to the WLC 3504.

B.Delete the WLC 3504 from Cisco DNA Center and add it to Cisco DNA Center again.

C.Add the WLC 3504 under the hierarchy of the Catalyst 9300 connected devices.

D.Copy the .pern file from the Cisco DNA Center on the USB and upload it to the WLC 3504.

Question 124

What are two functions of IPv6 Source Guard? (Choose two.)

A.It uses the populated binding table for allowing legitimate traffic.

B.It works independent from IPv6 neighbor discovery.

C.It denies traffic from unknown sources or unallocated addresses.

D.It denies traffic by inspecting neighbor discovery packets for specific pattern.

E.It blocks certain traffic by inspecting DHCP packets for specific sources.

Question 125

Drag and drop the MPLS terms from the left onto the correct definitions on the right.

Other Version: 10266Cisco.300-410.v2024-12-18.q447; 3708Cisco.300-410.v2023-04-25.q268; 3989Cisco.300-410.v2023-01-28.q148; 2287Cisco.300-410.v2022-11-26.q118; 3209Cisco.300-410.v2022-07-26.q136; 4018Cisco.300-410.v2022-05-02.q98; 7222Cisco.300-410.v2022-01-27.q256

Latest Upload: 288PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 424Nokia.4A0-113.v2026-05-01.q69; 453EC-COUNCIL.312-49v11.v2026-04-30.q214; 426Microsoft.MB-820.v2026-04-30.q101; 287Salesforce.MC-202.v2026-04-30.q57; 336BICSI.INSTC_V8.v2026-04-29.q53; 473NMLS.MLO.v2026-04-28.q82; 304NCARB.Project-Management.v2026-04-28.q27; 565EMC.D-AV-DY-23.v2026-04-27.q184; 1427ServiceNow.CSA.v2026-04-27.q483

Question 121

Question 122

Question 123

Question 124

Question 125

Download PDF File