Free Access Cisco.300-425.v2022-05-21.q101 Practice Test (Page 16)

Question 71

A customer has two Cisco 550B WLCs that manage all the access points in their network and provide N+1 redundancy and load balancing. The primary Cisco WLC has 60 licenses and the secondary Cisco WLC has 40. The customer wants to convert the N+1 model to an HA model and provide SSO. Configuration must be performed during a maintenance window. After performing all the configurations on both controllers, the config redundancy unit secondary command is issued on the secondary Cisco WLC and it fails. Which parameter needs to be in place to complete the configuration?

A.A cable in the RP port

B.The secondary Cisco WLC needs a minimum of 50 base licenses

C.The primary Cisco WLC is already set as the secondary unit.

D.SSO needs to be enabled

Question 72

Which statement about creating a mobility group is true, excluding mobility anchors?

A.Each WLC must use the same mobility name and be defined as a peer in each other's static mobility members list.

B.If WLCs with HA SSO are deployed, each WLC in the WLC HA pair considered separately as a mobility peer.

C.The WLCs do not have to be of the same model or type to be a member of a mobility group, however each member should be running different software versions.

D.A mobility groups does not require all WLCs in the group to use the same virtual IP address.

Question 73

An engineer performs a Layer 1 survey by using Metegeek chanalyzer only on the current operating channel. Which operating mode is configured for a Cisco CleanAIR AP?

A.Local

B.Sniffer

C.Monitor

D.SE-connect

Question 74

During a post deployment site survey, issues are found with non-Wi-Fi interference. What should the engineer use to identify the source of the interference?

A.Cisco Spectrum Expert

B.wireless intrusion prevention

C.Wireshark

D.network analysis module

Question 75

Which statement about creating a mobility group is true, excluding mobility anchors?

A.Each WLC must use the same mobility domain name and be defined as a peer in each other's static mobility members list.

B.If WLCs with HA SSO are deployed, each WLC in the WLC HA pair is considered separately as a mobility peer.