Free Access Cisco.300-425.v2022-10-21.q114 Practice Test (Page 14)

Question 61

When conducting a site survey for real-time traffic over wireless, which two design capabilities of smartphones and tablets must be considered? (Choose two.)

A.no support for 802.11ac

B.higher data rates than laptops

C.fewer antennas than laptops

D.no support for 802.11r

E.lower data rates than laptops

Question 62

Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?

A.When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.

B.When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

C.When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

D.When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

Question 63

Refer to the exhibit.

What is the main reason why the Wi-Fi design engineer took a different approach than installing the APs in the offices, even though that installation provides better coverage?

A.aesthetics

B.transmit power considerations

C.antenna gain

D.power supply considerations

Question 64

During a wireless network design, a customer requires wireless coverage on the perimeter of a building but also wants to minimize signal leakage from the wireless network. Which antenna should be used to accomplish this design?

A.Patch

B.Dipole

C.Monopole

D.Omnidirectional

Question 65

A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3x3 MIMO. Which reason explains this behavior?

A.A redundant power supply is unavailable on the switch.

B.The switch is 802.3af capable.

C.The AP is getting power from a power injector.

D.The switch is PoE+ capable.