In high-density environments, such as stadiums or auditoriums, APs are often mounted under the seats to provide a controlled cell size with attenuation. This placement helps to manage the RF environment by providing attenuation of 6 dB to 20 dB, which can reduce co-channel interference and improve the user experience by ensuring a strong signal and minimizing noise from other cells.

TPC - Transmit Power Control, sets to power to determine the cells boundary RXSOP - The higher the RX-SOP level, the less sensitive the radio is and the smaller the receiver cell size will be TSPEC - Traffic Specification, this is a QoS feature to prioritise traffic LSS - Location Specific Service, has to do with mDNS and Bonjour DFS - Dynamic Frequency Selection, is used to back off of radar bands in case radar signals are detected

To focus the coverage heat map on the desired coverage, the engineer should use the RSSI slider to set the heat map to the desired cutoff filter. This action will adjust the display to show only the signal levels that meet or exceed the specified RSSI value, effectively filtering out weaker signals and highlighting areas with sufficient coverage. References: Designing Cisco Enterprise Wireless Networks (ENWLSD 300-425)